The calculated move time was too low for moves where the spindle RPM was being clamped at either maximum or minimum RPM during the entire move. This bug only affected linear feed moves while constant surface speed was active. If the coordinate resolution setting was not '1.0' then this caused the 'K' 'Q' values to be incorrect.įixed a bug in the run time estimation calculations for lathe. When the 'K' or 'Q' addresses were used in an M98 block their values were incorrectly being adjusted by the coordinate resolution setting. This page contains settings that allow you to configure NCPlot settings related to macro functions. The configurations that are included in NCPlot have been updated to the new search character, but if you have customized configurations then the wildcard characters will need to be updated manually.Ī new configuration page has been added called 'Macro B Settings'. The wildcard search character has been changed from the asterisk '*' to the question mark '?' in the interpreter customize list.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |